ESAB MultiMaster 160, Инструкция по эксплуатации

Страница: 11 / 32

11
2.1 GENERAL
This manual has been prepared for experienced weld-
ers. Do NOT permit untrained persons to install, operate
or maintain this equipment. Do NOT attempt to install or
operate this equipment until you have read and fully un-
derstand these instructions.
This manual is intended for use in familiarizing personnel
with the design and operation of this equipment. All infor-
mation presented here should be read carefully before
installing and using this equipment.
2.2 RECEIVING-HANDLING
Upon receipt of this equipment, clean all packing material
from around the unit and immediately inspect for any dam-
age that may have occurred during shipment. Any claims
for loss or damage occurring in transit must be filed with
the carrier. The carrier will furnish a copy of the bill of
lading and the freight bill on request, if the need to file a
damage claim arises.
When requesting information regarding this equipment,
make sure that you include product name, part number,
and serial number.
2.3 SAFETY
The safety section at the front of this manual should be
read completely before attempting to install and operate
this equipment. Both equipment and personnel hazards
are reduced if proper safety precautions are taken. If you
are unsure of yourself in any situation, ask your supervi-
sor or other experienced personnel for help.
SECTION 2 INTRODUCTION
and tubular cored wires. This unit is suitable for carbon
steel and stainless steel. It provides a power source with
built in wire feeder.
2.4.2 PACKAGE CONTENTS (Standard Accessories)
Each Multimaster 160 package includes:
• Power source with built-in wire feeder.
• Gun Master 250 Mig Gun with .035" accessories.
• Dual groove feed rolls for .030/.035” core wire
• 10' work cable and clamp.
• 8' primary cable with plug.
• Mig Welding Handbook and set-up guide.
• Tig Welding Handbook
• Coreshield 15—.035 x 10# Spool
• LV 6013 Stick Electrodes 1#
2.4.4 POWER SOURCE
The power source is a DC output designed for single phase
primary connections. An output controlled fan provides
proper cooling during normal welding operations If the duty
cycle is exceeded, the unit will automatically shut down
and the Over Temperature light will illuminate. Once the
unit reaches a safe operating temperature, the unit will
automatically reset and welding can resume..
2.4.5 WIRE FEEDER
The wire feeder is built into the power source cabinet.
Cooling air is not drawn through the wire feeder compart-
ment or electronic controls reducing exposure to dirt and
dust which improves product performance and reliability.
The wire feeder pushes wire at speeds from 65 to 650
ipm (inches per minute).
2.4.6 CONTROLS
The Multimaster 160 can be used to weld solid and flux
cored wires. The operator selects the process desired on
a three position switch located on the front panel. A de-
tailed description of the power source controls is included
in Section 4 (Operation) of this manual.
2.4.8 MXL 200 MIG GUN
This air-cooled welding gun is supplied complete and ready
to weld .030 in. flux cored wire. Other wire sizes and types
can be used. Refer to Section 2, for other wire size and
alloy accessories.
Means immediate hazards which, if not
avoided, will result in immediate, serious
personal injury or loss of life.
Means potential hazards which could
result in personal injury or loss of life.
Means hazards which could result in mi-
nor personal injury.
2.4 DESCRIPTION
The Multimaster 160 is a DC welding system designed
for Mig (GMAW), Tig (GTAW) or Stick (SMAW) welding.
In the Mig mode this unit is capable of operating with short
arc or spray arc transfer and handles both solid wires