ESAB Fabricator 252i, Руководство по эксплуатации

Страница: 25 / 76

ESAB FABRICATOR 252i
Manual 0-5423 3-13 INTRODUCTION
3.08 Attaching the ESAB Fusion 250A MIG Gun
1. Unscrew the Locking Screw in the MIG Gun Adapter located inside the Wire Feed Compartment.
2. Push the ESAB Fusion 250A MIG Gun into MIG Gun Adaptor firmly using a twisting action.
3. Lock the ESAB Fusion 250A MIG Gun into the MIG Gun Adaptor by turning the Locking Screw clockwise in the MIG Gun
Adapter within the Wire Feed Compartment to secure the ESAB Fusion 250A MIG Gun in position.
NOTE!
Failure to properly lock the ESAB Fusion 250A MIG Gun into the MIG Gun Adapter will result in the ESAB Fu-
sion 250A MIG Gun being pushed out of the MIG Gun Adapter by the MIG welding wire or lack of shielding
gas (porosity in the weld) at the weld zone.
+
-
Attach MIG Gun
and secure.
Art # A-10548
Remote Cable 8 pin connector
Figure 3-8: Mount Fusion MIG Gun Cable to Adapter Socket
4. If equipped, align the keyways of the MIG Gun Switch connector pigtail with the 8 pin receptacle to the right of the MIG Gun
cable and plug them together. Secure by turning the locking ring to the right (clockwise ). Refer to Figure 3-8.
NOTE!
When disconnecting the MIG Gun trigger switch leads from the machine, DO NOT pull on the wires. Loosen
the locking ring and gently pull the plug out of the socket.
3.09 Installing a 12.5 lb spool (8" diameter)
In order to fit a 12.5 lb spool (8" diameter) assemble parts in the sequence shown in Figure 3-9.
Installation of wire spool.
1. Remove Wire Spool Hub Retaining Clip. Grasp the loop and pull.
2. Place Wire Spool onto the hub, loading it so that the wire will feed off the bottom of the spool as the spool rotates counter
clockwise. Make sure to align the spool alignment pin on the hub with the mating hole in the wire spool.
3. Replace the Wire Spool Hub Retaining Clip in the set of holes closest to the spool.
NOTE!
The Hub tension has been pre-adjusted at the factory. However if adjustment is required, refer to section
3.16
!
CAUTION
Use care in handling the spooled wire as it will tend to “unravel” when loosened from the spool. Grasp the
end of the wire firmly and don’t let go of it.