ESAB Cutmaster 100 SL100 1Torch, Руководство по эксплуатации

Страница: 79 / 122

ESAB CUTMASTER 120
300X5398 OPERATION
4T-5
A-02986
Trigger
Trigger Release
6. Bring the torch within transfer distance to the
work. The main arc will transfer to the work, and
the pilot arc will shut off.
NOTE!
The gas preflow and postflow are a
characteristic of the power supply
and not a function of the torch.
3
4
Art # A-03383
Trigger
2
1
Trigger Release
7. Cut as usual. Simply release the trigger assem-
bly to stop cutting.
8. Follow normal recommended cutting practices as
provided in the power supply operator's manual.
NOTE!
When the shield cup is properly in-
stalled, there is a slight gap between
the shield cup and the torch handle.
Gas vents through this gap as part
of normal operation. Do not attempt
to force the shield cup to close this
gap. Forcing the shield cup against
the torch head or torch handle can
damage components.
Piercing With Hand Torch
1. The torch can be comfortably held in one hand
or steadied with two hands. Position the hand to
press the Trigger on the torch handle. With the
hand torch, the hand may be positioned close to
the torch head for maximum control or near the
back end for maximum heat protection. Choose
the technique that feels most comfortable and
allows good control and movement.
NOTE!
The tip should never come in con-
tact with the workpiece except dur-
ing drag cutting operations.
2. Angle the torch slightly to direct blowback par-
ticles away from the torch tip (and operator)
rather than directly back into it until the pierce is
complete.
3. In a portion of the unwanted metal start the
pierce off the cutting line and then continue the
cut onto the line. Hold the torch perpendicular to
the workpiece after the pierce is complete.
4. Hold the torch away from your body.
5. Slide the trigger release toward the back of the
torch handle while simultaneously squeezing the
trigger. The pilot arc will start.
A-02986
Trigger
Trigger Release
6. Bring the torch within transfer distance to the
work. The main arc will transfer to the work, and
the pilot arc will shut off.