ESAB CIGWELD WeldSkill 205AC/DC, Руководство по эксплуатации

Страница: 15 / 72

0-5555 2-1 INTRODUCTION
SECTION 2:
INTRODUCTION
2.02 Equipment Identification
The unit’s identification number (specification or
part number), model, and serial number usually ap-
pear on a nameplate attached to the control panel. In
some cases, the nameplate may be attached to the
rear panel. Equipment which does not have a control
panel such as gun and cable assemblies is identified
only by the specification or part number printed on
the shipping container. Record these numbers on the
bottom of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If
there is any damage, notify the carrier immediately to
file a claim. Furnish complete information concerning
damage claims or shipping errors to the location in
your area listed in the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-
crate the unit.
2.01 How To Use This Manual
This Owners Manual only applies to the Part Numbers
listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular at-
tention to the information provided under these head-
ings. These special annotations are easily recognized
as follows:
NOTE!
An operation, procedure, or back-
ground information which requires
additional emphasis or is helpful in
efficient operation of the system.
!
WARNING
A procedure which, if not properly
followed, may cause injury to the op-
erator or others in the operating area.
!
CAUTION
A procedure which, if not properly
followed, may cause damage to the
equipment.
WARNING
Gives information regarding possible
electrical shock injury. Warnings will
be enclosed in a box such as this.
!
DANGER
Means immediate hazards which, if
not avoided, will result in immediate,
serious personal injury or loss of life.
Additional copies of this manual may be purchased
by contacting CIGWELD at the address and phone
number for your location listed in the inside back cover
of this manual. Include the Owner’s Manual number
and equipment identification numbers.
Electronic copies of this manual can also be down-
loaded at no charge in Acrobat PDF format by going
to the CIGWELD web site listed below and clicking on
the Literature Library link:
http://www.cigweld.com.au