ESAB CIGWELD EasyWeld 130, Руководство по эксплуатации, Страница: 9 / 66

EasyWeld / HandyWeld 130
0-5618 1-1 GENERAL INFORMATION
1.01 Arc Welding Hazards
WARNING
ELECTRIC SHOCK can kill.
Touching live electrical parts can cause fatal
shocks or severe burns. The electrode and work
circuit is electrically live whenever the output
is on. The input power circuit and machine
internal circuits are also live when power is on.
In semiautomatic or automatic wire welding, the
wire, wire reel, drive roll housing, and all metal
parts touching the welding wire are electrically
live. Incorrectly installed or improperly grounded
equipment is a hazard.
1. Do not touch live electrical parts.
2. Wear dry, hole-free insulating gloves and body
protection.
3. Insulate yourself from work and ground using
dry insulating mats or covers.
4. Disconnect input power or stop engine before
installing or servicing this equipment. Lock
input power disconnect switch open, or remove
line fuses so power cannot be turned on acci-
dentally.
5. Properly install and ground this equipment
according to its Owner’s Manual and national,
state, and local codes.
6. Turn off all equipment when not in use. Discon-
nect power to equipment if it will be left unat-
tended or out of service.
7. Use fully insulated electrode holders. Never dip
holder in water to cool it or lay it down on the
ground or the work surface. Do not touch hold-
ers connected to two welding machines at the
same time or touch other people with the holder
or electrode.
8. Do not use worn, damaged, undersized, or
poorly spliced cables.
9. Do not wrap cables around your body.
10. Ground the workpiece to a good electrical
(earth) ground.
11. Do not touch electrode while in contact with the
work (ground) circuit.
12. Use only well-maintained equipment. Repair or
replace damaged parts at once.
13. In confined spaces or damp locations, do
not use a welder with AC output unless it is
equipped with a voltage reducer. Use equipment
with DC output.
14. Wear a safety harness to prevent falling if work-
ing above floor level.
15. Keep all panels and covers securely in place.
SECTION 1:
ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
!!
WARNING
PROTECT YOURSELF AND OTHERS FROM POSSIBLE SERIOUS INJURY OR DEATH. KEEP CHILDREN AWAY. PACE-
MAKER WEARERS KEEP AWAY UNTIL CONSULTING YOUR DOCTOR. DO NOT LOSE THESE INSTRUCTIONS. READ
OPERATING/INSTRUCTION MANUAL BEFORE INSTALLING, OPERATING OR SERVICING THIS EQUIPMENT.
Welding products and welding processes can cause serious injury or death, or damage to other equipment or property, if
the operator does not strictly observe all safety rules and take precautionary actions.
Safe practices have developed from past experience in the use of welding and cutting machinery/equipment. These
practices must be learned through study and training before using this equipment. Some of these practices apply to
equipment connected to power lines; other practices apply to engine driven equipment. Anyone not having extensive
training in welding and cutting practices should not attempt to weld.
Safe practices are outlined in the Australian Standard AS1674.2-2007 entitled: Safety in welding and allied processes
Part 2: Electrical. This publication and other guides to what you should learn before operating this equipment are listed
at the end of these safety precautions.
HAVE ALL INSTALLATION, OPERATION, MAINTENANCE, AND REPAIR WORK
PERFORMED ONLY BY QUALIFIED PEOPLE.