ESAB CIGWELD EasyWeld 130, Руководство по эксплуатации, Страница: 40 / 66

MIG (GMAW) WELDING 5-8 Manual 0-5618
EasyWeld / HandyWeld 130
Wire Reel Brake
Adjustment Nut
Art # A-14865
Figure 5-10: Wire Reel Brake
5.07 Setup for MIG (FCAW) Welding with Gasless MIG Wire
A. Ensure that the Power Source On/Off switch located on the rear of the Power Source is in the Off position.
B. Connect the MIG Gun Polarity Lead (8) to the negative welding terminal (-). If in doubt, consult the wire
manufacturer. Welding current flows from the Power Source via Dinse terminals. It is essential, that the
male Dinse plug is inserted and turned securely to achieve a sound electrical connection.
C. Fit the correct Feed Roll for the Gasless MIG wire being used. Refer to section 2.11 Options and Accessories
for Feed Roll types and Part Numbers.
D. Place the MIG wire spool onto the spool holder. Refer to section 5.02.
E. Switch the Power Source On/Off switch located on the rear of the Power Source to the On position and
ensure the Power indicator on the Front Panel is illuminated.
F. Select MIG Gasless Mode using the Process Selection Control button. Refer to section 4.02.1 Page 4-1.
G. Feed wire through the wire drive mechanism. Refer to section 5.03.
!!
WARNING
Moving Parts can cause injury!
H. Connect the work lead to the positive welding terminal (+). If in doubt, consult the wire manufacturer.
Welding current flows from the Power Source via Dinse terminals. It is essential, that the male plug is
inserted and turned securely to achieve a sound electrical connection.
!!
WARNING
Before connecting the work clamp to the work piece make sure the mains power supply is switched off.
!!
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in the terminal.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the Welding Power Source.