ESAB CIGWELD EasyWeld 130, Руководство по эксплуатации, Страница: 39 / 66

Manual 0-5618 5-7 MIG (GMAW) WELDING
EasyWeld / HandyWeld 130
A dual groove feed roll is fitted as standard. It can accommodate 0.8/0.9mm Gasless Flux Cored Wires. Markings
are indicated on the side edge of the feed roll, for example 0.8, 0.9.
GROOVE “B” GROOVE “A”
GROOVE “B” SIZE GROOVE “A” SIZE
A-13577
Figure 5-8: Dual Groove Feed Roll
Feed Roll
Art # A-14864
Wire Drive
Tension Screw
Pressure Roller Arm
Feed Roll Retaining Cover
Figure 5-9: Changing the Feed Roll
5.06 Wire Reel Brake
When fitting the Wire Spool, the adjustment of the nut will control the MIG Wire Spool Brake. Clockwise
rotation of this nut tightens the brake. The Brake is correctly adjusted when the spool stops within 10 to 20mm
(measured at the outer edge of the spool) after MIG Gun trigger is released. Wire should be slack without
becoming dislodged from the spool.
!!
WARNING
Moving Parts can cause injury!
!!
CAUTION
Overtension of brake will cause rapid wear of mechanical WIREFEED parts, overheating of electrical componentry and
possibly an increased incidence of electrode wire Burnback into contact tip.