ESAB Caddy Arc 152i, Инструкция по эксплуатации

Страница: 7 / 28

© ESAB AB 2008
- 7 -
bh31d1e
4.1 Location
Place the power source so that its cooling air inlets and outlets are not obstructed.
4.2 Mains power supply
Check that the welding power source is connected
to the correct voltage and that the correct fuse
size is used.
The standards for the country in question must be
complied with as regards the mains cable area.
A protective earth connection must be made in
accordance with regulations
Location of rating plate
4.2.1 Recommended fuse sizes and minimum cable area
Arc 152i
Mains voltage
230 V 10 %, 1-phase
Mains cable area mm
2
3G2.5 mm
2
Phase current I
1eff
20 A
Welding cable, area 16 mm
2
Fuse
anti-surge
Type C MCB 20 A*)
32 A
*) NOTE! The installed plug is approved for max. 16A.
NOTE!
The cable area and fuse rating above comply with Swedish regulations. Use the welding power source
in accordance with the relevant national regulations.
GB