14
INITIAL CONDITIONS
-
The structure must be sufficiently robust and stable.
-
The door must open and close by hand with ease.
-
Correct any possible faults (excessive chafing, lack of greasing, warping, etc.)
INSTALLATION OF THE ACTUATOR
1.- Place the motor supports according with the corresponding diagram.
2.- Place the hydraulic lock on the bottom leaf of the door (model 615).
3.- Place the actuator on the support and fasten it with the screws supplied with the appliance.
4.- Balance the counterweights so that it moves neither up nor down.
5.- Connect the actuator to the control panel and check its functioning.
6.- Check the turn direction using the open and close pushbuttons on the control panel. If incorrect, change the positions of the G1 and
G2 cables.
7.- Place the hinges. To position the jackshaft, use the open and close pushbuttons on the manoeuvre control panel.
8.- Adjust the open and close pressures. The pressure increases as the screws are turned clockwise and it is reduced if they are turned anti-
clockwise.
Pressure
Open adjustment
Pressure
Close adjustment
Do not overtighten the screws.
9.- Programme the control panel in accord with the corresponding instructions.
10.- Connect the different accessories (photocell, garage light, etc.).
E
NGL
IS
H
