Pag. 13
Transmitter S/N configuration
Each transmitter is sold with a different Serial Number
(S/N). It is anyway possible to change this number using
the cable B with the special probe (see fig. on pag. 20 ).
For this operation connect the cable to the receiver
connector RJ11 ( Ref. 7 on pag. 2).
Select the option”Copy memory on a transmitter” :
Dial the desired S/N and confirm with the transmitter
MASTER.
The display asks for the connection:
You are asked for the Serial Number to set on the
transmitter
At this point open the battery door of the transmitter and
connect the probe to the 7 pads present on the bottom
of the transmitter card, as shown in fig. 13.
Confirm with the RIGHT key of the MASTER transmitter.
The software begins the check of the connection:
P R O G R A M T X
U S E R
S N 0 0 6 0 9
C O P Y M E M O R Y
O N A T R A N S M I T T E R
P R O G T X S N 0 0 6 0 9
C O N N E C T E D ?
Fig. 13
ALKAL
INE
P R O G T X S N 0 0 6 0 9
V E R I F Y .
.
.
Finally on the display appears the message : EXECUTED
OK. The procedure asks for another S/N to set and
propose the number next to the last S/N used .
NOTE
:
1) The S/N : “00000” cannot be used.
The receiver gives an error message;
2) The Facility Code memorized with the S/N is the same
of the first transmitter memorized which is allocated on
the position 1 of the memory
3) If the data transfer hasn’t carried out successfully, on
the display appears the message “CONNECTED?”
again.
