Pag. 10
Menu : Modify User
This procedure is at the item 3 of the main menu.
Through this procedure it is possible to carry out the
following actions on a USER transmitter, only if it is present
in the memory:
!
Modify the activated relay and the corresponding
transmitter key;
!
Enable or disable the single USER
M O D I F Y
U S E R
U S E R
S N
2 0 6 0 9
Set the Serial Number of the transmitter to modify by
using the 3 methods allowed ( TX MASTER, KEYPAD, Key
B of the USER TX )
Then give the confirmation with the key YES of the TX
MASTER
User Enable / Disable
The receiver checks the current situation and propose the
corresponding changement
- If the USER transmitter id enabled, it asks to disable;
- if the USER transmitter is enabled, it asks to enable
U S E R
S N 2 0 6 0 9
D I S A B L E U S E R ?
U S E R
S N
2 0 6 0 9
E N A B L E
U S E R ?
With a final YES appears the message EXECUTED OK,
the transmitter is disabled, the procedure ends and the
program returns to the main menu.
If the transmitter is currently disabled, you are asked to
enable.
With an answer YES the following message appears:
D I S A B L E U S E R
A R E Y O U
S U R E
?
With a final YES appears the message EXECUTED OK,
the transmitter is enabled, the procedure ends and the
program returns to the main menu.
With an answer YES the following message appears:
E N A B L E
U S E R
A R E Y O U
S U R E
?
Modify relay or key parameters
Once selected the Serial Number of the transmitter to
modify, you are asked to set the relay and the key
parameters:
U S E R
S N 2 0 6 0 9
R E L A Y O R K E Y ?
With a YES,it is displayed the current configuration of the
transmitter: activated relay and corresponding transmitter
key.
The following table shows the association between relays
and keys when the parameter RELAY is set to ½:
2-keys transmitter
Key Option
A
B
Activations
A - Relay 1
B - Relay 1
B - Relay 2
A - Relay 2
4-keys transmitter
Key Option
A
B
C
D
Activations
A -Relay 1 B -Relay 1 C -Relay 1 D -Relay 1
B -Relay 2 C -Relay 2 D -Relay 2 A -Relay 2
If the parameter RELAY is set to 1 or 2, only the key
indicated causes the activation of the relay.
U S E R
S N 2 0 6 0 9
R E L A Y : ½
K E Y : A
Once inside the options for the parameters RELAY and
KEY, scoll the options available with the LEFT key of the
TX MASTER and confirm with the RIGHT key.
OPTIONS RELAY : 1 - 2- ½ - 1- 2 - etc.
OPTIONI KEY : A - B - C - D - A - B - etc
.
At the end the message EXECUTED OK appears and the
program returns to the main menu.
NOTE
: If you entry the S/N of a transmitter not in
memory, the following message appears :
S N N O T I N M E M O R Y
U S E R
S N 2 0 6 0 9
