ERNITEC LON Box I151SX, Руководство по установке

Страница: 4 / 10

Installation
Unpacking the LON
®
Box
After unpacking the LON
®
Box, carefully check for any signs of damage. Any such damage
should be reported to your supplier, before installation.
Check that the packing carton contains the following items:
y
1 pcs. SYSTEM X LON
®
Box.
y
1 pcs. LON
®
Box X Installation Manual (this manual)
y
1 pcs. screw kit.
Box Installation
Choose a plane surface to prevent the box from being twisted and thereby becoming leaky.
When installed outdoor the box should be oriented with the cable glands pointing
downwards.
Drilling pattern is shown on the back of the box.
Box dimensions (excl. glands) are: 242 x 160 x 90mm (W x H x D).
Mains installation
The LON
®
Box can be supplied with either 115 VAC or 230 VAC mains voltage. The mains
voltage is selected by the mains voltage selection switch.
T1
MAINS IN
N L
SELECT
MAINS
J9
Ih
=
63
m
A
F1
S5
115
23
0
Mains selection switch
Mains input
L:
N:
:
Live
Neutral
Earth
The LON
®
Box must be used with a 3-wire mains connection (2W+PE @ min. 0,75mm
2
).
Terminals marked with hazardous live symbol requires installation by an instructed person.
If permanently connected to mains, a readily accessible disconnect device shall be
incorporated in the building installation wiring.
If pluggable connection to mains, the socket-outlet shall be installed near the equipment and
shall be easily accessible.
Note: The unit is equipped with two PTC-fuses with automatic reset function. In case of malfunc-
tion always return the unit for repair. The references below are intended for information only.
F1: (BC Components, type 2322 660 66393)
I
hold
= 63mA, I
trip
= 95mA, Initial resistance = 120R
F2: (BOURNS, type MF-R075)
I
hold
= 750mA, I
trip
= 1.5A, Initial resistance = 0R18
S Y S E M
Page 2 2853-00009