20
Tray Regulation Mode Setup
with Local Setpoint
External Setpoint Mode with
Remote 4-20mA Setpoint
OPERATION
RESULT (OR DISPLAY)
Turn the green power
switch “ON”
Control is energized
Press the red “O”
Feeder is turned “off” (STOP)
Press “P”
C 000
Press
scroll to
C 003
Press “P”
ESP 0
Press “P”
SP2 0
Press “P”
EN 0
Press “P”
STOP
Press “P”
C 000
Press
scroll to
C 008.
Press “P”
A 0.0
(set A to 0.0 using arrow keys)
Press “P”
P 100.0 (set P to 100.0 using
arrow keys)
Press “P”
F ** (should be factory set to
operating frequency)
Press “P”
ACC 1 (set ACC to 1 using
arrow keys)
Press “P”
PA 4.0 (set PA to 4.0 using
arrow keys)
Press “P”
IA 50
(set IA to 50 using arrow keys)
Press “P”
STOP
Press “P”
C 008.
Press
C 000
Press “P”
A 0.0
OPERATION
RESULT (OR DISPLAY)
Press green “I”
Feeder is energized
Press “P”
A 0.0
Press
scroll to
A 100.0
(This is full amplitude of the
feeder and should be noted)
Press red “O”
Feeder is turned “off” (STOP)
Turn the green power switch “OFF”, disconnect the power
supply, and make sure controller is wired for an external signal
for the setpoint (ie 4.-20mA) Turn the power source back on.
Turn the green power switch
“ON”
Control is energized
Press the red “O”
Feeder is turned “off” (STOP)
Press “P”
C 000
Press
scroll to
C 003
Press “P”
ESP 1 (set ESP to 1 using
arrow keys)
Press “P”
4..20.1 (set 4..20 to 1 using
arrow keys)
Press “P” repeatedly until
EN 1 (set EN to 1 using
arrow keys)
Press “P”
C 003
Press
scroll to
C 000
Press “P”
A 100.0
Press
scroll to
A 0.0
Press “P”
STOP
Press green “I”
Enables controller (0.0)
Using minimum external signal (i.e. 4.mA) Feeder is energized.
Increase signal to maximum slowly (i.e. 20mA) Maximum feeder
output 100.0 on display.
Press “P”
C 000
Press
scroll to
C 008.
Press “P” repeatedly until
P 100.0 (set P to 100.0 using
arrow keys)
Press
To achieve maximum federate
desired or leave at 100.0
(A = max)
Reduce external signal to minimum (i.e. 4.mA) Minimum federate
(A = min)
Press “P” repeatedly until
A 0.0
Press
To achieve minimum federate
desired or leave at 0.0
Press “P”
C 008.
Press
C 000
Press red “O”
To turn feeder off (C 000)
Press “P” repeatedly until
(STOP)
The controller can now be operated in the regulation
mode by pressing the green “I” to turn the controller
on. Press the
to set the desired amplitude of the
feeder. Read the amplitude sticker on the feeder to
confirm the displacement.
