Ericsson S-825 Series, Руководство по установке, Страница: 27 / 36

10
Table 1. Power vs. Current Setting
STANDARD RANGR RADIO
RATED POWER & CURRENT
Maximum & Typical
RANGR MOTORCYCLE
RADIO ADJUSTED POWER &
CURRENT Maximum & Typical
29-50 MHz
60 watts @ 13 Amps Maximum
(10.4 Amps Typical)
30 watts @ 9.5 Amps Maximum
(7.6 Amps Typical)
136-174 MHz
40 watts @13 Amps Maximum
(10 Amps Typical)
25 watts @10.5 Amps Maximum
(8 Amps Typical)
403-512 MHz
35/30 watts @13 Amps Maximum
(11 Amps Typical)l
25 watts @ 11 Amps Maximum
(9.4 Amps Typical)
806-870 MHz
35 watts @ 15 Amps Maximum
(10.4 Amps Typical)
25 watts @ 13 Amps Maximum
(9.1 Amps Typical)
3. Insert the large rubber grommet into the metal cable cutout and slide
the cable cutout w/ grommet into the slot on the bottom of the
weatherproof box. Secure with the two 1/4 X 20 machine screws and
locking nuts provided. See Figure 4.
4. Insert the two smaller grommets into the two holes adjacent to the
cable cutout.
5. Remove the backing from the plastic wire holder. Locate a position on
the opposite side of the case from the cable cutout approximately 3/4-
inch from and parallel with the front and 2.5 inches from the outside
edge. Press the holder into position.
When installing the ground straps, be sure they are
dressed in such a way that they will not get pinched
between the mounting plate and the weatherproof box
when the shock absorbers are fully compressed.
NOTE
6. Install the four 4-inch radio ground straps (provided) with the
weatherproof case mounting screw through the ring terminal. The flat
side of the ring terminal should be face down.
27
Figure 19. Power Control Cable Outline Diagram