Ericsson S-825 Series, Руководство по установке, Страница: 13 / 36

24
Figure 16. Antenna Mounting (Rear Mount Option)
FINAL CHECKS AND CONNECTIONS
After the weatherproof case is installed and all cables run, connect the
power/control plug to the radio, connect the antenna to the radio, and
connect the cable shield ground to the radio case with the metric screw
provided with the Power/Control Cable as shown in Figure 17, Radio
Connections.
Make a final check of all cables to make sure they are properly connected
and dressed away from all moving parts and exhaust pipes, and secured
with cable ties. Then recheck all electrical connections and radio mounting
hardware.
To ensure optimum performance, make sure the cable
shield ground lead is connected to the radio case.
NOTE
SERVICE NOTE: Refer to the control unit maintenance manual for the
required initial adjustments.
13
Figure 6. Radio Top Mounting Bracket Installation
If you are installing a radio that has not been modified
for motorcycle applications, refer to “Radio
Modification Procedures” and modify the radio before
continuing.
NOTE
4. Refer to Figure 7 and position the radio and top mounting plate
assembly over the bottom mounting plate. Align the holes in the two
mounting plates (two on each side) and secure with the four machine
screws (N30AP16010), lockwashers (N406P39), and (N400P9) flat
washer provided. Secure the spade lugs of the 4-inch grounding straps
between screws (N30AP16010) and mounting plates.
When installing the ground straps, be sure they are
dressed in such a way that they will not get pinched
between the mounting plate and the weatherproof box
when the shock absorbers are fully compressed.
NOTE
5. If an optional rear-mount antenna is not used, install the supplied
grommet in the cable entrance cover plate and insert 1/4-20 x 3/4"
screw, flat washer, and nut to seal the grommet.