Ericsson S-825 Series, Руководство по установке, Страница: 14 / 36

14
Figure 7. Radio and Base Plate Mounting
Radio Modification Procedures
Applies only to radios that have not been modified for
motorcycle applications.
NOTE
Prior to installing the radio in the weatherproof box, the radio must be
modified to withstand the mechanical vibrations inherent to motorcycle
applications. Refer to Figure 8, RANGR application assembly.
1. Remove and discard standard RANGR mounting screw, spring, and
washer.
2. Remove backing from rubber pad 19B802204P1 and attach to top
mounting plate 19D903777P1 as shown.
3. Remove RANGR bottom cover and four cone shaped mounting feet.
Discard cone shaped mounting feet.
4. Put a small drop of RTV on each end of the receive oscillator crystal to
stake the crystal to the printed board.
5. Assemble RANGR bottom cover and mounting plate 19D903777P1 to
the bottom of the RANGR using four 344A4064P1 screws. Torque to
21 inch-pounds.
6. Remove and discard RANGR top cover.
7. The synthesizer is located under a casting on the top side of the
RANGR radio. Re-torque all screws on the synthesizer casting and
synthesizer printed board to 8.5 inch-pounds.
23
Figure 14. Antenna Mounting (Top Mount Position)
Figure 15. Antenna Modifications