Ericsson DUAL FORMAT MDR, Руководство по установке

Страница: 21 / 28

Be careful to avoid damaging some vital part (fuel tank, transmission
housing, etc.) of the vehicle when drilling mounting holes. Always check
to see how far the mounting screws will extend below the mounting
surface before installing.
CAUTION
If pilot holes must be drilled, remove all metal shavings from drilling holes
before installing screws.
CAUTION
Radio installations in vehicles powered by liquefied petroleum gas must
conform to the following requirements.
WARNING
EQUIPMENT REQUIRED
The equipment required for installing the Dual Format MDR Mobile Radio is
listed below:
••
Electric drill for drilling mounting holes.
••
Drills and circle cutters as follows:
••
No. 31 (1/8-inch) drill for No. 8 self-tapping screws.
••
No. 27 (9/64-inch) drill for No. 10 self-tapping screws.
••
5/8-inch drill or circle cutter for power cable.
••
3/4-inch circle cutter, hole saw or socket punch for antenna
(optional).
••
Phillips and flat-blade screwdrivers, and 1/4-inch and 5/16-inch
hex-head drivers for mounting screws.
••
No. 15 Torx® driver (ST0606).
••
No. 15 Torx® tamper-proof driver (ST0618) if latch security
screw (supplied in hardware kit) is used.
••
No. 25 Torx® driver (ST0610).
••
POZIDRIV® driver for mounting screws.
Torx® is a registered trademark of CAMCAR Division TEXTRON. Inc.
POZIDRIV® is a registered trademark of Phillips International company.
8
NOTE
The relay contact make/break current and voltage rating is 30 amps at 16
volts.
(1) Relay (19A149299P1)
(1) Fuse holder
(1) Fuse, 1 amp, 250 volt
4 feet red wire, AWG #18 with Ring Tongue Terminal for 3/8 stud 6 feet
black wire, AWG #18 with Molex #39-00-0060 terminal
(5) Insulated 1/4 inch spade tab receptacles
(1) Ring Tongue Terminal for 3/8 inch stud
(1) #8 x 3/4 long Type A sheet metal screw
(1) Nut Plate for #8 screw
1. Install the option cable kit - option PMCD7Z in the radio.
2. Fasten the relay in the desired location, close to the voltage source, using one
#8 x 3/4 inch self-tapping screw.
3. Crimp an insulated 1/4 inch spade tab receptacle to one end of the #18 red wire.
Connect the receptacle to relay lug #86. Cut the red lead so the fuse assembly
is close to the voltage source. Install the fuse holder. Attach the other end of
the fuse lead to the voltage source with appropriate hardware. See Figure 11.
4. Insert the black wire with the Molex terminal into pin 13 of the option
connector housing supplied with the option cable. Plug the connector into the
option cable.
5. Crimp an insulated 1/4 inch spade tab receptacle to the other end of the black
wire. Connect the receptacle to relay lug #85.
6. Connect the horn or light circuit to lugs #30 and #87 (not 87a) using the
insulated 1/4 inch spade tab receptacles.
TALK-AROUND KIT - OPTION PMTA1B
Refer to the talk-around kit option installation manual that is included with this
option.
21