Ericsson DUAL FORMAT MDR, Руководство по установке

Страница: 18 / 28

A permanent mount type of antenna should be located in the center of the roof
or center of rear deck. Glass mounted antennas should be kept as high as possible
in the top center of the rear window. Some states have laws restricting vision
obstructing items from the windows. Be familiar with local laws before installing
glass mount antennas.
Try to route the cable away from locations where it will be exposed to heat,
sharp edges or mechanical damage, and where it will be out of the way of the driver,
passengers or vehicles mechanics. Wherever possible, existing holes in the trunk-
wall, and the channels above or beneath doors and window columns should be
utilized.
Avoid routing the antenna cable near any electronic modules or along side any
vehicle wiring.
Connect the antenna cable to the TNC connector on the radio being careful not
to twist the cable.
OPTION CABLE KIT - OPTION PMCD7Z
The option cable kit brings all option connections from the System Board
through the back of the radio to the outside. This cable is required with all external
options. Supplied with the option cable is the empty connector housing which plugs
into P2 of the option cable. Pins supplied on the ends of the wires of each option
(Molex #39-00-0060) are inserted into this connector housing. Refer to the inter-
connection diagrams at the back of this manual. See Figure 9 for pin locations. Table
2 lists wire connections and functions.
1. Remove the bottom cover of the radio by removing the four bottom cover
retaining screws. This also releases the top cover.
2. Remove the rubber plug from the option access opening in the rear of the radio
adjacent to the power cable. Refer to Figure 3.
3. Plug the option cable into J905 on the System Board and push the strain relief
on the cable into the slotted option access opening. Refer to Figure 10.
4. Replace the covers and the four bottom retaining screws.
Option cable 19C851585G14 has been replaced with 19C851585G18. The
G18 is a direct replacement and provides a data interface.
NOTE
18
Figure 3 - Power Cable
4. Push the prepared fuse connectors into each section of the fuse holders. Place
the fuse into a fuse holder section until it seats within the connector. Connect
the fuse holder sections to insure a tight fit and connection.
11