Ericsson DUAL FORMAT MDR, Руководство по установке

Страница: 13 / 28

3. Loosen the large knurl nut (item 5 in Figure 7) on the underside of the holder
to position the holder to a comfortable position.
4. Tighten the knurl nut when the handset and holder are in the correct position.
NOTE
The positive latch handset holder may be installed as a swivel unit or as a
low profile unit. To convert to the low profile unit refer to Figure 7 and
perform the steps below.
1. Loosen the knurl nut (item 5) and remove the holder. Remove the screw and
washer (item 2) in the bottom of the base (item 3) holding the swivel ball stud
(item 4). Remove the knurl nut from the swivel ball stud.
2. Insert the nut (item 6) into the recess on the retainer washer (item 7) and then
place the retainer washer inside the knurl nut. Fasten the retainer washer and
knurl nut to the base with the screw and washer removed in Step 1 above.
Attach the holder to the base with the knurl nut.
Figure 7 - Handset Holder Base Breakdown
16
Figure 4 - Mounting Dimensions
Coil any surplus cables and secure them out of the way with the retaining strap
provided. Be sure to leave some slack in the cables going to the radio so that it may
be pulled out for servicing with power applied.
MOUNTING THE RADIO
Use the supplied mounting bracket as a template to locate the positions for each
of the drill holes. Mount the radio as shown in Figure 5. Be sure to leave enough
room at the rear of the radio for the cable connections.
13