Rotate the encoder A/DATA to navigate to the SETTINGS menu and push to confirm.
Here you can adjust master settings of the module. Three setting pages are available: System
information, Audio output and Display settings.
Rotate the encoder A/DATA to navigate to the relevant menu and push to confirm.
In the Info screen you chac chek your current firware and bootloader version. Also you can
enable "Autoload".
In the Display settings menu you can set the display contrast. OLED auto dimming - this will
reduce the contrast automatically if module is not used for 1 minute.
Channel popup - with this setting you can enable or disable channel selection popup.
CV popup - this option if enabled will show the CV offset for settings which have the CV control
enabled.
In the output screen you can set the output levels for ach of the sided (1&2) and also see the
scope of each output.
Maximum setting (100) sets the output level to 10V ptp.
Autoload automatically loads the last opened project in its saved state after power up of the
module.
TR1 & TR2 DELAY:
This setting allows you to delay the incoming trigger because depending on the sequencer
used CV or Trigger signal can arrive with latency between them. By adjusting the Trigger
delay you can find the "sweet spot" between latency and precision. Setting is saved within
project.
Auto calibration: Remove all cables from CV inputs and press encoder E and confirm to start
the auto calibration process. This will calibrate the CV inputs.
SETTINGS MENU – MAIN SYSTEM AND USER SETTINGS
GENERAL
SAMPLE DRUM
