Ergon Crafco Patcher I Diesel, Инструкция по эксплуатации и запасным частям

Страница: 23 / 37

23
HOT APPLIED PATCHING MATERIAL PLACEMENT
Prior to the material application you will need to move the equipment to the work area. The
items needed are:
1. Compressor
2. Saw to cut out repair area
3. Pneumatic hammer
4. Broom and shovels to clean up area
5. Broom or sweeper (if required to remove FOD)
6. TechCrete machine, material, and application tools
7. Dressing stone
8. Heat lance
9. Primer
10. “Hudson” sprayer for the primer
11. Paint brushes
12. Small paint cans
13. Rags
14. 1 or 2 gallons of water (to speed up cooling process if required)
15. Gloves, heavy welder gloves and standard leather gloves
16. Cloth duct tape
17. Reference materials
APPLICATION STEPS
1. Locate area to be repaired.
2. Mark the areas to be cut out. Make sure you cut out enough of the pavement to remove
all cracking around the patch area. If the repair area extends to both sides of a joint, the
repair area must be a minimum of 4” on each side of the joint.
3. Cut with either a wet or dry saw. The saw should cut a minimum of 1-1/2” to 2” deep.
4. Remove the remaining material with a chipping or jack hammer to a minimum depth of
1-1/2 to 2”.
5. After the repair area has all the loose material removed, use the hot air lance to clean
and dry the pavement.
6. Apply tape 1/4” from the edge of the prepared area.
7. Prime the area with the Primer using the “Hudson” sprayer or paint brushes.
If spraying the primer on repair areas, you may need to do some touch-up with a paint
brush. When touching up, you want to cover any missed spots and spread any pooled
primer. Allow the primer to set up which takes about 10-12 minutes. DO NOT DRY
WITH A TORCH.