Flying Your Model
Your model has been designed for the intermediate modeler
who is familiar with the use of a four-channel radio system.
It is available in Mode 1 and Mode 2. Always perform a
range and flight check to make sure all controls are operating
properly before flying your model.
Range check:
Connect the Li-Poly battery to the aircraft, before turning on
the TX press CH3-, keep the button pressed down and turn
on the transmitter. You will hear 5 consecutive tones, you are
now in range check mode. 10 metres distance from the model
in range check mode is equivalent to around 100 metres
range in normanl flying mode. Move the transmitter sticks to ensure all channels are working. To return
to normal flying mode turn off the transmitter and turn it back on again, you will hear 3 beeps to confirm
you are back in normal flying mode.
Setting the trim before flight
It may be neccessary to fine trim your model before flight, with all transmitter sticks in neutral all control
surfaces should be at neutral position.
✔
✖
DIGITAL TRIMS:
CH2:
Elevator trim buttons
(+ for up and - for down)
CH3:
Throttle trim buttons
(+ for increase and - for decrease)
CH4:
Rudder trim buttons
(+ for right and - for left)
Ch1 -
Ch1 +
Ch4 - Ch4 +
Ch3 -
Ch3 +
Ch2 -
Ch2 +
Mode 2
Ch1 -
Ch1 +
Ch4 - Ch4 +
Ch2 -
Ch2 +
Ch3 -
Ch3 +
Mode 1
Servo reverse
Servo directions are factory set and should move in the correct direction. To reverse servo direction
follow this procedure:
Ch2 Elevator servo reverse:
Press Ch1+ and Ch2+ or - simultaneously
Ch4 Rudder servo reverse:
Press Ch1+ and Ch4+ or - simultaneously
Содержание Micro Stik
Страница 1: ......
