Binding the Model
Your model is shipped ready to fly. If you find the
ontrols are not responding to the transmitter, it may be
necessary to bind the radio system. Use the following
to bind the radio system.
1. Turn on the transmitter
2. Install the flight battery and connect the plug
3. Momentarily depress the 2 trim buttons on the
throttle stick Note: Throttle is on the right for Mode
1 and left for Mode 2.
Note:
You do not need to hold them down
4. The airplane will indicate that it is bound by moving
the controls
5. Check that the control surfaces are moving in the
correct direction
Control Throw
Make sure the controls for your model operate
correctly.
Elevator Control
Moving the elevator stick (mode 2-right, mode 1-left)
to the top of the transmitter will make the elevator
move down. In the air, this will cause the plane to dive.
Moving the stick toward the bottom of the transmitter
will make the elevator go up. In flight this will make the
model climb.
Rudder Control
Moving the right stick to the right will make the rudder
go right. In flight this will make the model turn to the
right. Moving the stick to the left will make the rudder
go left. In flight this will make the model turn to the left.
Throttle Control
Moving the throttle stick (mode 2 - left, mode 1 - right)
to the top of the transmitter will operate the motor.
The throttle is proportional, so as you move the
throttle stick up, the speed of the motor will increase,
which increases the flying speed of the model. We
recommend flying at 1/4 to 2/3 throttle for your first
flight to learn the flying characteristics of your model.
Mode 1
Down Elevator
Mode 2
Mode 1
Mode 2
Up Elevator
Mode 2 and Mode 1
Left Aileron
Mode 2 and Mode 1
Right Aileron
Throttle
Mode 2
Mode 1
Note:
Your radio does have a 4th channel, but is not a
function designed into this particular model.
Содержание Micro Stik
Страница 1: ......
