Erbauer ERI490CSW, Оригинальное руководство пользователя

Страница: 16 / 24

oPERATIoN INSTRUCTIoNS
Note: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for lengthways and
crossways cutting of wood with straight cutting lines
as well as bevel angles to 50° while resting firmly on
the work piece.
CHARGING PROCEDURE
1. BEFORE USING YOUR CORDLESS CIRCULAR
SAW
Your battery pack is UNCHARGED and you must
charge once before use.
Warning: Only use charger ERB424CHR to
charge battery ERI489BAT, The charger and
battery pack are specifically designed to work together
so do not attempt to use any other devices. Never
insert or allow metallic objects into your charger or
battery pack connections because an electrical failure
and hazard will occur.
2. INSTALL THE CHARGER STANDS (See Fig.1-1,
1-2 & 1-3)
There are 2 working positions for charger, two
charger stands was provided for charger standing,
slide the two charger stands (32) into the both
grooves on back of the charger (29). The charger
can stand as shown in Fig.1-3
3. CHARGE THE BATTERY PACK (See Fig.1-4)
Connect the battery charger to the power supply and
the green light (30) will illuminate. Slide the battery
pack (16) into the charger to make the connections.
The green light (30) will be off and the red light
(31) will illuminate to show charging has started. A
discharged battery at normal ambient temperature
will take approximately 1 hour to reach full charge.
When charging is completed the green light (30) will
illuminate while the red light (31) is off.
Warning: When battery charge runs out after
continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before
re-charging to achieve the full charge.
Note: This charger is designed to detect some
problems that can arise with battery pack. (see table
below)
Fig 1-1
Fig 1-2
Fig 1-4
16
30
31
32
29
16
30
31
A
29
16
30
31
A
29
Fig 1-3
16
30
31