Erbauer ERB704SSW, Инструкция по безопасности и эксплуатации

Страница: 14 / 30

ERBAUER 457MM SCROLL SAW ERB704SSW
DROP FOOT ADJUSTMENT (Fig. 2)
To prevent workpiece from lifting, the drop foot (16)
should be rests flat above the workpiece and the
drop foot adjusted so it is parallel to the working
table when angle cutting. The drop foot should not
be adjusted so that the workpiece drags.
Always retighten the drop foot lock knob (25) after
each adjustment has been made.
- To adjust, loosen the screw (33), tilt the drop foot
(16) so it is parallel to the working table, and
tighten the screw.
- Loosen the drop foot lock knob (25) to raise or
lower the drop foot until it just rests on top of the
workpiece. Tighten the knob.
- Loosen the horizontal adjustment screw (34) with
hex key 5mm (28) supplied, then move the drop
foot forward or backward as needed.
The tall, front part of the drop foot acts as a blade
protector to prevent accidental contact with the
blade.
DUST BLOWER ADJUSTEMT (Fig. 3)
The attached dust blower (4) is designed to direct
air to the cutting line. Adjust the dust blower to
the desired position. For the best results, always
direct air flow at the blade and the workpiece.
LED LIGHT ADJUSTEMT (Fig. 4)
With an easy ON/OFF switch, the attached LED
light (24) keeps the cutting line on the workpiece
lighted for more accurate scroll cut. Adjust the
LED light to the desired position.
Reducing Noise and Vibration:
You may wish to place a foam pad or piece
of carpet between the saw base and the workbench
to help reduce noise and vibration.
If a foam pad or piece of carpet is used, do
not overtighten the mounting bolts. Leave some
cushion between the padding and the saw base to
help absorb the noise and vibration.
The thickness of the padding material should be
approximately 1/2" (13 mm).
Fig. 2
16
33 34
25
Fig. 3
4
Fig. 4
24