Erbauer ERB704SSW, Инструкция по безопасности и эксплуатации

Страница: 19 / 30

ERBAUER 457MM SCROLL SAW ERB704SSW
OPERATION INSTRUCTION
RECOMMENDATIONS FOR CUTTING
A scroll saw is basically a curve-cutting machine.
It can also be used for straight cutting and beveling
or angle cutting operations. Please read and
understand the following items before attempting
to use the saw.
- When feeding the workpiece into the blade,
do not force it against the blade. This could cause
blade deflection. Allow the saw to cut the material
by guiding the workpiece into the blade as it cuts.
- The blade teeth cut material ONLY on the down
stroke.
- Guide the wood into the blade slowly because the
teeth of the blade are very small and remove wood
only on the down stroke.
- Best results are achieved when cutting wood 1"
(2.5 cm) thick or less.
- When cutting wood thicker than 1" (2.5 cm), guide
the wood very, very slowly into the blade and take
extra care not to bend or twist the blade while
cutting in order to maximize blade life.
- Teeth on scroll saw blades wear out and the blades
must be replaced frequently for best cutting results.
Scroll saw blades generally stay sharp for 30
minutes to two hours of cutting.
- To get accurate cuts, be prepared to compensate
for the blade's tendency to follow the wood grain
as you are cutting.
- This scroll saw is primarily designed to cut wood
or wood products. For cutting precious and non-
ferrous metals, the variable control switch must
be set at very slow speeds.
- When choosing a blade, use very fine, narrow
blades to scroll cut in thin wood 1/4" (0.6 cm) thick
or less. Use wider blades for thicker materials,
but this will reduce the ability to cut tight curves.
- Blades wear faster when cutting plywood or very
abrasive particle board. Angle cutting in hardwoods
wears blades down faster.
NOTE:
The saw is primarily intended for
woodworking. If it is being used for
woodworking, choose a suitable device that prevents
you from inhaling the dust. Insert the nozzle to a
standard vacuum hose.