Erbauer ERB383WCH, Оригинальное руководство пользователя

Страница: 7 / 28

1500W WALL CHASER
ADDITIONAL SAFETY RULES FOR YOUR WALL CHASER
a) The guard provided with the tool must be securely attached
to the power tool and positioned for maximum safety, so
the least amount of wheel is exposed towards the operator.
Position yourself and bystanders away from the plane of the
rotating wheel.
The guard helps to protect operator from broken
wheel fragments and accidental contact with wheel.
b) Use only bonded reinforced or diamond cut-off wheels for
your power tool. Just because an accessory can be attached to
your power tool, it does not assure safe operation.
c) The rated speed of the accessory must be at least equal to
the maximum speed marked on the power tool. Accessories
running faster than their rated speed can break and ly apart.
d) Wheels must be used only for recommended applications.
For example: do not grind with the side of cut-off wheel.
Abrasive cut-off wheels are intended for peripheral grinding, side
forces applied to these wheels may cause them to shatter.
e) Always use undamaged wheel langes that are of correct
diameter for your selected wheel
. Proper wheel langes support
the wheel thus reducing the possibility of wheel breakage.
f) Do not use worn down reinforced wheels from larger power
tools. Wheels intended for a larger power tool are not suitable for
the higher speed of a smaller tool and may burst.
g) The outside diameter and the thickness of your accessory
must be within the capacity rating of your power tool.
Incorrectly sized accessories cannot be adequately guarded or
controlled.
h) The arbour size of wheels and langes must properly it the
spindle of the power tool.
Wheels and langes with arbour holes
that do not match the mounting hardware of the power tool will run
out of balance, vibrate excessively and may cause loss of control.
i) Do not use damaged wheels. Before each use, inspect
the wheels for chips and cracks. If power tool or wheel is
dropped, inspect for damage or install an undamaged wheel.
After inspecting and installing the wheel, position yourself
and bystanders away from the plane of the rotating wheel and
run the power tool at maximum no load speed for one minute.
Damaged wheels will normally break apart during this test time.