Erbauer ERB337TCB, Инструкция по безопасности и эксплуатации

Страница: 16 / 19

CUTTING AN ANGLE OR BEVEL
Use the 45° vertical fence if you wish to cut an
angle or bevel on the tile edge. lift the 45° vertical
fence inserting the plastic tabs into the
corresponding holes on the table. Then make the
cut as before.
Internal or external bevel cuts can be made by
turning the tile face up or down (internal - eg.wall
corner; external - eg. window reveal).
MAINTENANCE
Ensure that appliance is disconnected from
supply before installation, before cleaning and
maintenance operations.
Apart from diamond discs there are no other user
serviceable parts inside this tile cutter.Refer to
qualified service personnel if internal maintenance
is required. Any worn, or damaged parts should
be replaced immediately by qualified personnel.
Keep discs in good condition. Poor condition or
worn discs can increase the noise level emitted.
Do not allow dust to accumulate inside, or on the
product. After use, clean all excess dust from the
table and the area around the table.Frequently
clean the machine using a soft brush or vacuum
cleaner.
If the supply cable is damaged, it should be
replaced by the same type of cable as the one
provided and recommended by the manufacturer
(H05 VV-F 3G0.75 mm²). The supply cord of the
tool and any extension cord used should be
checked frequently for damage. If damaged, have
the cordset replaced by an authorised service
facility. Replace the extension cord if necessary.
Fig 13
Green & Yellow E(Earht)
Blue
(neutral)
N
5amp fuse
approved to
BS1362
Brown
(live)
L
Cable grip
Outer sleeve
5amp
PLUG REPLACEMENT
If you need to replace the fitted plug then follow
the instructions below.
IMPORTANT: The wires in the mains lead are
coloured in accordance with the following code:
Blue – Neutral
Brown – Live
Green/Yellow – Earth
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in