Erbauer ERB2002, Руководство пользователя

Страница: 11 / 19

230mm Angle Grinder
3. FITTING THE DISCS
(See Fig. 3a, Fig. 3b, Fig. 3c)
Put the Inner flange (4) onto the spindle (1). En-
sure it is located on the two flats of spindle (See
Fig. 3a). Place the grinding disc (2) on the spindle
(1) and disc flange. Ensure it is correctly located.
Fit the threaded outer flange making sure it is
facing in the correct direction for the type of disc
fitted.
For cutting disc, the flange is fitted with the
raised portion facing away from the disc (See
Fig. 3b). Press in the spindle lock button (8) and
rotate the spindle (1) by hand until it is locked.
Keeping the lock button (8) pressed in, tighten
the locking nut (5) with the spanner (11) provid-
ed. (See Fig. 3c)
WARNING:
Never use discs with the
Max specified rotation speed smaller than
6,650 /min (80 m/s). Do not attempt to op-
erate the spindle lock button (8) while the
disc is rotating.
4. SWITCH
(See Fig. 4, Fig. 4a)
The On/Off switch (7) is incorporated with a
locking button (10) to avoid accidental starting.
To start the grinder first push the On/Off switch
locking button (10) forward, then press the On/
Off switch (7) (See Fig. 4a). To turn off the grind-
er simply release the On/Off switch (7).
5. TO USE THE GRINDER
(See Fig. 5a, Fig. 5b)
ATTENTION:
Do not switch the grinder on
whilst the disc is in contact with the work piece.
Allow the disc to reach full speed before starting
to grind.
Hold your angle grinder with one hand on the
main handle and other hand firmly around the
auxiliary handle (6).
Always position the disc guard (3) so that as
much of the exposed disc (2) as possible is point-
ing away from you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control, material removal and mini-
Fig. 3c
Fig. 4
Fig. 4a
Fig. 5a
15º–30°
Grinding