Erbauer ERB2002, Руководство пользователя

Страница: 6 / 19

4
HEALTH ADVICE
WARNING!
When drilling, sanding, sawing or grinding, dust particles will be
produced. In some instances, depending on the materials you are working
with, this dust can be particularly harmful to you (e.g. lead from old gloss
paint).
You are advised to consider the risks associated with the materials you are working
with and to reduce the risk of exposure. You should:
- Work in a well-ventilated area.
- Work with approved safety equipment, such as those dust masks that are specially
designed to filter microscopic particles.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR
ANGLE GRINDER
1. If the supply cord is damaged have it replaced by a qualified person.
2. Check that the speed marked on the wheel is equal to or greater than the rated
speed of the grinder.
3. Ensure that the wheel dimensions are compatible with the grinder.
4. Abrasive wheels shall be stored and handled with care in accordance with manu-
facturer’s instructions.
5. Inspect the grinder wheel before use. Do not use chipped, cracked or otherwise
defective products.
6. Ensure that mounted wheels/discs and parts are fitted in accordance with the
manufacturer’s instructions.
7. Ensure that the abrasive product is correctly mounted and tightened before use
and run the tool at no-load for 30 seconds in a safe position. Stop immediately if
there is considerable vibration or if other defects are detected. If this condition oc-
curs, check the machine to determine the cause.
8. If a guard is supplied with the tool never use the tool without such a guard.
9. Do not use separate reducing bushings or adapters to adapt large hole abrasive
wheels.
10. For tools intended to be fitted with a threaded hole, ensure that the thread in the
wheel is long enough to accept the spindle length.
11. Check that the work piece is properly supported.
12. Do not use cut off wheel for side grinding.
13. Ensure that sparks resulting from use do not create a hazard e.g. do not hit per-
sons, or ignite flammable substances.
14. Ensure that ventilation openings are kept clear when working in dusty conditions.
If it should become necessary to clear dust, first disconnect the tool from the
mains supply and then using non metallic tools, clear the dust from the slots and
while avoiding damaging internal parts.
15. For cleaning, always use eye and ear protection. Other personal protective equip-
ment such as dust mask. gloves, helmet and apron should be worn.
16. The wheel continues to rotate after the tool is switched off.