Erbauer ERB180C, Руководство пользователя, Страница: 9 / 12

720W Tile Cutter
6. CUTTING WITH THE TABLE AT AN ANGLE
(see fig7)
Use this facility if you wish to cut an angle.
Loosen the two table securing knobs (one at each
side of table).
Tilt the table to the desired angle using the scale
under the table (see fig7). Re secure the table and
make the cut as before.
7. ADJUSTING THE BLADE GUARD BRACKET
AND BLADE GUARD
(see fig8)
Note: The blade guard bracket should be in
alignment with the plane of the blade, if not, the
blade guard bracket must be adjusted:
First, Take off the blade guard, then loosen the
two screws on the bracket, adjust the blade guard
bracket to align with the plane of the blade, then
screw down the two screws. Then refit the blade
guard, See fig8.
MAINTENANCE
CHANGING THE BLADE
1.Take away the water tray.
2.Remove the blade guard cover by loosening the
two screws. See fig9.
3. Loosen and remove the blade fixing nut. You
will need two spanners, A (8mm) and B (19mm)
-Not Supplied. See fig10.
4. Remove the outer flange and the blade, clean
any dust and debris from the arbor and blade
securing flange.
5. Mount the blade on the arbor and place the
outer flange. Turn the blade 360 degrees to make
sure it matches with the flange properly. Fully
tighten the securing nut.
Note:
Fit the inner and outer flange in proper
order. They have the different centre holes. See
fig11.
Ensure that the arbor and flange are clean.
Match blade direction arrow to blade rotation
direction (wording on wheel facing you).
6. Fit the blade guard spacing plate behind the
blade and the blade guard cover over the blade.
Fix these two parts using the washers and screws
provided. See fig12.
Note:
After changing the blade, ensure the table
guard bracket and the table are on the same
vertical plane.
Fig 5
Fig 6
Fig 7
Fig 8