Problem
Possible cause
The electric motor
becomes hot and
cuts out.
The machine is
switched on but will
not run.
Cutting is difficult
and the channel
made is irregular.
When cutting, the
workpiece begins to
vibrate heavily.
The machine runs
erratically and / or
noisily,
Solution
1) The overheating
protection has been
activated.
2) The motor is defective.
1) The overload protection
has been activated.
2) The overheating
protection has been
activated.
3) The switch is damaged.
The cutting discs are bent
or blunt.
The cutting discs are
overheated or deformed.
The carbon brushes are
worn.
1) Wait several minutes until
the machine has cooled down,
then re-start the machine.
2) Take the machine to your
dealer for inspection and / or
repair.
1) Re-start the machine.
2) Wait several minutes until
the machine has cooled down,
and then re-start the machine.
3) Take the machine to your
dealer for inspection and / or
repair.
Replace the cutting discs.
Replace the cutting discs.
Take the machine to your
dealer for replacement of the
carbon brushes.
MAINTENANCE
Содержание ERB125Y
