EQUATION 82823691, Инструкция по эксплуатации

Страница: 29 / 32

FR
ES
PT
IT
EL
PL
UA
RO
EN
29
INTRODUCTION
The room thermostat turns the heating system on and off to obtain the desired temperature (set
temperature). It detects the air temperature and compares it with the set temperature. If the room
temperature is lower than the set temperature, the thermostat turns on the boiler, and turns it off when
the set temperature is reached, and so on.
Energy effi ciency is ensured by a self learning TPI control algorithm, which adapts to the environment
and provides tight temperature regulation with minimal energy consumption. To obtain an optimum
setting, set a low temperature (18°C for example) and increase degree by degree each day to reach the
temperature that suits you (comfort temperature).
The thermostat does not aff ect the power of the boiler, so there is no need to set a higher temperature
to heat faster.
If the radiators have valves (manual or thermostatic) make sure that the radiators located in the same
room as the thermostat are open.
The thermostat is compatible with modulating boilers, but with a reduction in performance.
INSTALLATION
The thermostat must be installed on a wall away from any source of heat (fi replace, radiator, sun) and
drafts (window, door), at a height of 1.2 m to 1.5 m.
It must be connected to the inputs for a “ON/OFF” remote thermostat (T1 and T2) of a boiler, regardless
of the polarity. The diagram on the label stuck in the box corresponds to the particular case of a series
connection to the boiler supply. In this case, it is important to connect phase (L) to terminal 1 of the
thermostat.
The installation must be carried out by a person possessing the required qualifi cations while respecting
the national wiring standards in force.
Inserting the batteries
1 - Insert 2 AA (LR06) 1,5V batteries in the compartment. Make sure
you observe the right polarity (“+” and “-”).
2 - Close the cover
Important !
• Do not let children play with batteries
• Do not ingest batteries
• Non-rechargeable batteries are not to be recharged;
• Diff erent types of batteries are not to be mixed;
• New and used batteries are not to be mixed;
• Batteries are to be inserted with the correct polarity;
• Exhausted or leaking batteries are to be removed from the
appliance and safely disposed of;
• If the appliance is to be stored unused for a long period,
batteries should be removed;
• The supply terminals are not to be short-circuited.
• The batteries must be removed from the appliance before it
is scrapped.
+ -
- +