Equalizer SG11TM, Руководство по эксплуатации и обслуживанию

Страница: 46 / 76

44 IM_SGM_07
Fault A pair of collets are jammed in a bolt hole.
Possible
Cause A collet which is too small or large has been selected, or the collet has
been inserted into a damaged or non-round bolt hole.
Corrective
Action The flange must be spread before removal can be attempted. This can be
done using another pair of Secure Grip tools, or another method if available.
Removal can be achieved as follows:
1. On both sides, pull the collet spring plunger ring out, and remove the rest
of the tool, leaving the collet head assemblies in the bolt hole.
2. On both sides, unscrew the collet nut and remove the drive cone and
collet cone.
3. On the left-hand side, screw the collet nut back on to the collet holder
until it is 1 - 2 mm off the end.
4. Using a hammer and a suitable drift, move the collet holder until it is
possible to cut off the tapered end of the collet holder.
5. Cut off the tapered end with a hack saw or other cutting tool.
6. Withdraw the collet holder from the bolt hole.
7. Using a hammer and a suitable drift, move the collet holder on the right-
hand side up to the left-hand side collet and drive it out.
8. Drive the right-hand side collet out using the collet holder.
2 mm
Cut Here