7.1. Commissioning the base station
• Open the battery compartment on the back of the base station.
• Insert three batteries (AA cells) with the correct polarity into the battery
compartment. Use preferably alkaline batteries..
It is possible to use rechargeable batteries but these reduce the
operational life due to their lower voltage / capacity.
• Close battery compartment.
• After you have inserted the batteries, all segments of the LCD are
displayed briefly, followed by a version number.
• After that, the base station activates the synchronization mode for
10 minutes.
During this time the display shows ”SY”, thereunder appears a counter,
that counts down the 10 minutes.
• After synchronizing the display shows the following data:
Upper row („Display panel A”, see next page):
- If no sensor received: Temperature of the integrated sensor (indoor
temperature)
- If one sensor received: Temperature of this sensor
- If more than one sensor received: Temperature of the sensor with ad-
dress 8 (this is the pool sensor S 300PT-US in factory setting), or with
the lowest sensor address.
If you have changed the address on the pool sensor S 300PT-US,
you have to change the display panel A to this address (1...8,
see chapter 9.2.1.).
Lower row (”Display panel B”, see next page):
- Temperature and air humidity of the integrated sensor
Additional you can see the associated comfort indicator and tendency
indicator.
• You can either hang the base station on a wall (there is a corresponding
opening on the back) or place it on a level surface with the installation
base.
• If you want to use the foot, first put the booth lower spikes of the foot
into the supports on the back side of the base station (below the battery
compartment). Then, swing the foot a little bit to the front till the two other
spikes lock into the catch supports at the buttom of the base station.
F
F
