- To choose another sensor, press the key ”SENSOR” long till the dis-
play in the display panel B disappears and at right the symbol for the
sensor address is blinking.
- Now press the key ”SENSOR” frequently short, till the required sensor
address and in display panel A the data of this sensor is displayed.
- If you don´t press any key for 10 seconds or shortly press the key
”MIN/MAX” or ”SELECT”, the device goes back to normal mode.
Now the data of display panel B appears again (indoor sensor or the
selected outdoor sensor).
•
You can only choose active sensors, that means, the base station
must already received data from this sensor at earlier time. The
unit skips not occupied addresses.
•
By choosing sensors 1...8 the water symbol appears.
•
By choosing the combination sensor the sensor address ”9” ap-
pears.
•
By choosing the indoor sensor no sensor address appears.
9.2.2. Display panel B - Indoor or outdoor sensor
In the base setting the panel B shows the indoor tempera-
ture and the indoor air humidity.
If required, you can allocate any sensor to this panel.
- For choosing a sensor, press the key ”SENSOR” frequently short, till the
required sensor address and in display panel B the data of this sensor
is displayed.
•
You can only choose active sensors, that means, the base station
must already received data from this sensor at earlier time. The
device skips not occupied addresses.
•
By choosing the combination sensor the sensor address ”9” ap-
pears.
•
By choosing the indoor sensor no sensor address appears.
•
If the device is still in the selection mode for display panel A,
please wait either, till the panel B is displayed again, or press
the key ”SENSOR” long, till display panel B appears again.
Now the sensor selection for display panel B is activated.
F
F
F
