42
43
7.2 Teaching-in
Please read this entire section before starting
the teach-in procedure .
To integrate the switching actuator into your Home-
Matic system and enable it to communicate with other
HomeMatic devices (e .g . HomeMatic Remote Control),
you must teach it in first. You can teach-in the swit
-
ching acutator directly to other HomeMatic devices or
to the HomeMatic Central Control Unit:
7.2.1 Teaching-in to HomeMatic devices
If you would like to teach-in the switching acutator to
one or more HomeMatic devices, you must put the
devices to be taught-in into teach-in mode and select
the required teach-in channel . To do this, proceed as
follows:
During teach-in, please make sure you maintain
a distance of at least 50 cm between the de-
vices .
•
Activate the teach-in mode of your switching actua-
tor . Therefore, press and hold down the channel but-
ton for at least 4 seconds. The device LED will flash
continuously to indicate that teach-in mode is active .
The teach-in time is 20 seconds .
•
Now put the device you wish to teach-in the swit-
ching actuator into teach-in mode . Please follow the
relevant operating manual instructions of the corre-
sponding device .
If no teach-in is carried out, teach-in mode will be
exited automatically after 20 seconds . If other de-
vices are also in teach-in mode, they will be
taught-in .
7.2.2 Teaching in to a HomeMatic CCU
Your device can be conveniently
• controlled and configured,
•
connected directly to other devices or
•
used in central control programs
via the HomeMatic software „WebUI“ . Therefore,
your switching acutator has to be taught-in to the
HomeMatic Central Control Unit first. New devices are
taught-in to the Central Control Unit via the HomeMatic
„WebUI“ .
