Rev.03242022JA
7 | S\N: 203E +
2.
Wireless trigger
(Item B)
: The wireless trigger allows your screen to synchronize its drop/ rise operation with the
projector’s power cycle.
Wireless Trigger Set Up Instructions
A. Wireless trigger and Twilight Electric projection screen set up [CODE] button:
1. Unplug the Power Cable attached to your motorized Elite Screen from the wall.
2. Connect the Projector’s Power Cable to the wireless trigger, then plug the cable into a nearby power outlet.
3. Locate the [CODE] button on the back of the trigger, then, using a small pin, press and hold the [CODE]
button.
4. When you see the LED indicator light flashing rapidly, plug the screen’s power cord into a nearby outlet.
The screen will go up and down slightly. Release the [CODE] button at this point (you may hear a beep
sound from the screen).
5. Within 3 seconds after releasing the [CODE] button, press and hold the [CODE] button again until you see
the LED indicator light flashing rapidly (the screen will go up and down slightly), this means the
synchronization (pairing) process is successful.
6. If unsuccessful repeat from Step 1.
B. Wireless trigger and projector set up [SET] button:
1
.
Plug the wireless trigger’s IEC cable into the projector’s power receptacle.
2.
Power ON the projector. The screen should drop automatically.
3. Locate the [SET] button on the back of the trigger,
then (using a small pin) press and hold the
[SET] button
for about 3 seconds until LED indicator light flashes and you hear a beep sound.
4. Turn off the projector within 10 seconds after the LED indicator light emits a flash and a beep.
5. At this step in the process, the trigger will record the running current of the projector when it is turned off,
and then the process is completed.
6. Power ON the projector. The screen should drop automatically.
7. Power OFF the projector. The screen should retract automatically.
8. If unsuccessful repeat from Step 1.
Projector
[SET] Button
[CODE] Button:
For programming the receiver
[SET] Button:
For setting the trigger feature
[CODE] Button
LED indicator light
AC power input
120VAC 60Hz
(Optional 220VAC 50Hz)
Note
➢
When powering off the projector,
assure it is completely powered off
(ex, fan off), then the screen will
retract automatically
➢
If the motorized screen does not
automatically drop or retract, repeat
the process from Step 1.
Back of wireless trigger
