Rev.03242022JA
6 | S\N: 203E +
Screen removal from the Mounting Brackets
Pull down on the
Mounting Bracket Release
Tab
and remove the bottom case away from
the wall/ceiling followed by the top of the case.
`
Twilight Electric Control System and Operation
Twilight Electric Series Controls
A. RF Remote Control x1 pc (Battery built-in)
B. Wireless trigger x1pc
Screen operation
Electric Current: 110v.
1. After ensuring the power outlet & screen are compatible (voltage), plug the power cord into the power outlet.
2. Once the screen has power, you’ll be able to control it using any of the
2 methods
described below.
2 ways to control your Twilight Electric Screen
1. RF Remote Control
(
Item A
): The radio waves eliminate the need for a direct line of sight.
Radio Frequency (RF) Remote Synchronization Instructions
1.
Make sure the screen’s power cable is not plugged into a power outlet (If so, then unplug it).
2.
Press and HOLD the UP button on the RF remote until you see the flashing light turn solid. (See diagram
above)
3.
While holding the UP button, plug the screen’s power cable into the power outlet. The screen will drop
slightly (you may hear a beep) indicating it has entered pairing mode.
4.
Release the UP button for 3 seconds, then press UP button again until you see the flashing light turn
solid (the screen will go up and down slightly).
5.
You should now be able to control your electric screen with the RF remote control.
6.
If unsuccessful repeat from Step 1.
Note: The beep(s) the screen produces are very faint. It may be difficult to hear, if more than 5 feet away from
the screen.
UP
STOP
DOWN
