Epson TM-T70II, Техническое справочное руководство

Страница: 69 / 156

Chapter 2 Setup
69
2
Drawer connection diagram
Setting the Internal Buzzer (for Models with an Internal Buzzer)
Models w it h t he b u zzer f un c ti o n ca n beep t he b u zzer whe n t he drawer i s ope n ed, by se tting t he
proper ti es of t he dr i ver or o ut p utting a p u lse s ign al by a comma n d. The int er n al b u zzer ca nn o t
cha ng e t he b u zzer vol u me a n d so un d pa tt er n b ut ca n cha ng e t he b u zzer freq u e n cy. Whe n u s ing
t he int er n al b u zzer, yo u n eed t o e n able t he int er n al b u zzer w it h t he memory sw it ch.
The b u zzer se tting i s performed by se tting t he memory sw it ches for t he b u zzer a n d spec i fy ing
co nn ec t or p in nu mbers t o wh i ch a comma n d o ut p ut s a p u lse s ign al, as show n in t he t able below.
For in forma ti o n abo ut t he memory sw it ches, see "Se tting t he Memory Sw it ches/Rece i p t
E n ha n ceme nt " o n pa g e 54
Memory
switch
Specified connector pin ON OFF Initial setting
Buzzer
frequency
(Pulse 1)
Drawer kick out connector pin 2 Buzzer beeps.
Buzzer does not
beep.
OFF
Buzzer
frequency
(Pulse 2)
Drawer kick out connector pin 5 Buzzer beeps.
Buzzer does not
beep.
ON
Since the buzzer drive signal and the cash drawer drive signal are common in the printer,
do not use the same connector pin numbers to output the signal for the buzzer and the
cash drawer.

For detailed information about ESC/POS commands, see the ESC/POS Command Ref-
erence.

For detailed information about the driver control, see the manual for each driver.
With shielded
Drawer kick-out connector
Printer side
User side [Drawer kick-out side]
Drawer open/close switch
Drawer kick-out solenoid
Control device