Epson SureColor F7200, Руководство пользователя

Страница: 40 / 208

2 Top margin
1
,
2
You can configure this margin in the RIP software to 0.2 inch (5 mm) and above; if you set it
below 0.2 inch (5 mm), it is changed to 0.2 inch (5 mm) to maintain feeding accuracy. The margin
differs based on how far the media was pulled during loading.
When printing at 360 × 720 in the following modes, specific margins are set:
• 2 pass: 0.75 inch (19 mm)
• 3 pass: 0.83 inch (21 mm)
3 Left margin
3
,
4
You select this margin as the Side Margin(Left) setting on the product control panel. The default
setting is 0.2 inch (5 mm), but you can select from 0.12 inch (3 mm) to 0.98 inch (25 mm).
4 Right margin
3
,
4
You select this margin as the total of the values for the Print Start Position (default setting is 0)
and Side Margin(Right) (default setting is 0.2 inch [5 mm]) settings on the product control panel.
You can select from 0.12 inch (3 mm) to 32.5 inches (825 mm).
5 Media width
11.8 to 64 inches (300 mm to 1626 mm); if Media Size Check is off, the product assumes this is
64 inches (1626 mm) regardless of the actual width
1
The configured margin and the actual print results may differ depending on the RIP software you use.
Contact the RIP manufacturer for more information.
2
When you set the Margin Between Pages setting to the No Margin option on the product control
panel, you can adjust the margin from –0.39 inch (–10 mm) to 0.39 inch (10 mm).
3
Depending on the RIP software, you may be able to use it to set these margins. Contact the RIP
manufacturer for more information.
4
When using the media holding plates, leave margins of at least 0.4 inch (10 mm) to avoid printing over
the plates. If the total of the print data width and left and right margins exceeds the printable area, a
portion of the print data will not print.
Parent topic: Media Handling
Related references
Printer Setup Menu Settings
40