Epson Stylus Photo R3000 Series, Руководство по обслуживанию

Страница: 52 / 73

Confidential
Adjustment Details of Adjustments (TBD) 52
Epson Stylus Photo R3000 Revision A
2.2.6 MAC address setting
 Setting procedure
1. After replacing the Main Board, note down the MAC address written on a label on the Shield Plate Lower.
2. Connect the printer and the PC with the USB cable.
3. Start the Adjustment Program.
4. Select the “Initial Setting” from the menu. The initial setting screen appears.
5. Enter the last six digits of MAC address into the MAC address entry field, and click the MAC Address input
button. (Enter the address again into the second entry field to confirm it.)
6. Select the network status sheet print menu on the printer’s control panel, and print the sheet. Check the MAC
address printed on the sheet to see if it is correct.
Figure 2-21. MAC Address Setting Screen
 This setting is not necessary when the data in EEPROM on the Main Board can be read out.
 To avoid a conflict of MAC address on a network, make sure to correctly follow the MAC
address setting flowchart given on the following.
 The user should be notified of the change of MAC address because of the following reasons.
• If the user has set the printer’s MAC address on a router, the repaired printer with a
new MAC address cannot be connected to the network.
• The default printer name on a network consists of “EPSON” and the last six digits of the
MAC address. Therefore, the printer name becomes different from the previous one.
 You are required to enter the last six digits of the MAC address (xx:yy:zz) on the
Adjustment Program.
MAC address example: 00:00:48:xx:yy:zz
(“xx, yy, zz” represents a value unique to each printer)
Figure 2-20. MAC Address Label
MAC Address Label
Last six digits of MAC address
Shield Plate Lower