Epson RX580 - Stylus Photo Color Inkjet, Руководство по обслуживанию

Страница: 45 / 107

EPSON Stylus PHOTO RX560/580/590 Revision A
Disassembly and Assembly Removal of Exterior Parts 45
4.2.4 Main Board
1. Remove the Panel Assy (p.42)
2. Peel off the acetate tape (x4).
3. Disconnect all the FFCs and connectors from the Main Board.
4. Remove the screws (x5), and remove the Main Board Assy by lifting its rear side.
(Fig. 4-11)
5. Remove the screw, and remove the Shield Plate M/B Support. (Fig. 4-12)
6. Remove the screws (x2), and remove the Shield Plate. (Fig. 4-12)
7. Remove the screws (x5), and remove the Main Board. (Fig. 4-13)
(Continued to next page)
Figure 4-11. Removing the Main Board Assy
Figure 4-12. Removing the Shield Plate
Figure 4-13. Removing the Main Board
A D J U S T M E N T
R E Q U I R E D
When the Main Board is to be replaced, back up the data in
EEPROM before starting disassembly, if possible. After assembly,
make the following adjustment.
„
5.1.1 Adjustment by Use of Adjustment Program (p.74)
C A U T I O N
The Shield Plate may be burred. Be sure to wear gloves to avoid
injury from burrs.
C.B.P-TITE 3x10 (x4)
Torque : 0.6±0.1N
·
m
1
2
5
4
3
C.B.S 3x6
Torque : 0.8±0.1N
·
m
C.B. 3x8
Torque : 0.6±0.1N
·
m
Shield Plate M/B
Support
C.B.S-TITE 3x8 (x3)
Torque : 0.6±0.1N
·
m
Shield Plate M/B
2
1
3
4
C.B 3x12
Torque : 0.8±0.1N
·
m
3
C.B.S-TITE 3x8 (x2)
Torque : 0.8±0.1N
·
m
C.B.S-TITE 2.5x 6
Torque : 0.4±0.1N
·
m
1
2
4