Epson PLQ-30, Руководство пользователя

Страница: 20 / 139

Olivetti Mode PR2
Wincor Nixdorf Mode WNI4915
IBM Mode IBM4722
EPSON Mode ESC/P2, IBM PPDS, ESC/P2+ESC/MC
Follow these steps to adjust the top-of-form position:
Note:
❏
The factory set default for the top-of-form position is set as shown below.
PR2: 4.2 mm
EPSON Mode, IBM4722: 8.5 mm
WNI4915: 9.8 mm
❏
This mode can be used even when the printer cover is open.
❏
If you wish to change the top-of-form position in PR40+, make sure that you set the TOF position for
PR40+ to Off.
❏
Your top-of-form position setting remains in effect until you change it, even if you turn off the
printer.
❏
The top margin setting made in some application software overrides the top-of-form position setting
you make with this function. If necessary, adjust the top-of-form position in your software.
❏
Prepare an A4 size sheet of paper before using this function.
1. Select the Target Printer Mode which corresponds to the emulation you wish to change setting.
See “About Your Printer’s Default Settings” on page 54.
2. Turn off the printer.
!
Caution:
Whenever you turn off the printer, wait at least five seconds before turning it back on;
otherwise you may damage the printer.
3. Turn on the printer while holding the Offline and F2 button.
4. Press the F1/Eject button while the Offline light is flashing.
5. When the Ready light turns on, insert a sheet of A4 paper into the front slot. The printer prints
triple H in capitals (HHH) on the current top-of-form position and ejects the sheet.
PLQ-30/PLQ-30M User’s Guide
Paper Handling 20