Epson EU-m30 Series, Руководство разработчика

Страница: 36 / 85

29
that time.
Also, if the time from the completion of a print job (end of operation) to the start of the next print job is less
than 640 ms, the next print job will start without flashing.
For details, see 3.5.2 Software setting.
*5 A Near-End Error (orange) LED and Printing Completed (blue/attention) LED will not flash at the same
time.
3.5 Printer Setting
3.5.1 DIP switch settings
This printer is not equipped with DIP switches.
3.5.2 Software setting
(1) Memory switches
Can be changed using one of the following methods.
(a) User setup commands: GS ( E
Step 1: Moves to the user setting mode with GS ( E <Function 1>
Step 2: Change settings with GS ( E <Function 3>.
Step 3: End the user setting mode with GS ( E <Function 2>.
For details, see "ESC/POS Command Reference" ( www.epson-biz.com/pos/reference/ ).
(b) Software setting mode (except some functions)
For details, see 3.8.3 Software setting mode.
(c) EU-m30 Utility
Table 3.5.1 Memory Switch 1 (Msw1)
Msw Function Setting value Factory
setting
48 (OFF) 49 (ON)
1-1 (Reserved) - - 48 (OFF)
1-2 Receive buffer capacity 4 KB 45 bytes 48 (OFF)
1-3 Condition for BUSY Receive buffer full
and offline Receive buffer full 48 (OFF)
1-4 Data processing with reception error Replace with "?" Ignored 48 (OFF)
1-5 Automatic line feed Always disabled Always enabled 48 (OFF)
1-6 (Reserved) - - 48 (OFF)
1-7 Pin 6: Reset signal selection Not used Used 48 (OFF)
1-8 (Reserved) - - 48 (OFF)
1 segment: 160 ms

Elapsed time

ERROR LED
Flashing LED
 
640 ms
 
640 ms