Epson EB-Z10000, Руководство по установке, Страница: 8 / 84

Notes on Connection
Attention
•
If the input source is on when you connect it to the projector, it could cause
a malfunction.
•
If the orientation or shape of the plug differs, do not try to force it in. The
device could be damaged or could malfunction.
•
If the power cord and the connection cable are bundled together, noise may
occur.
Notes on Lens
Attention
•
Only remove the lens unit when necessary. If dust or dirt enter the projector,
projection quality deteriorates and it could cause a malfunction.
•
When replacing the lens unit, turn off the power beforehand.
•
If the lens shift has been done, set the lens shift to the center before replacing
the lens unit.
s
"Adjusting the Position of the Projected Image (Lens Shift)" p.22
•
Try not to touch the lens section with your hand or fingers. If fingerprints or
oils are left on the surface of the lens, projection quality deteriorates.
•
Do not attach the lens unit when the projector's lens insertion section is
facing up. Dust or dirt could enter the projector.
•
Store the projector with the lens unit installed.
If the projector is stored without the lens unit, dust and dirt may get inside
the projector and cause malfunctions or lower the quality of projection.
Notes on Security
Attention
•
If an incorrect password is entered three times in succession, the message
"The projector's operation will be locked." is displayed for approximately five
minutes, and then the projector switches to standby mode. If this happens,
disconnect the power plug from the electrical outlet and then reinsert it and
turn the projector's power back on. The projector displays the password entry
screen again so that you can enter the correct password.
•
If you have forgotten the password, make a note of the "
Request Code
:
xxxxx" number that appears on the screen and contact the nearest address
provided in the Epson Projector Contact List.
•
If you continue to repeat the above operation and input the wrong password
thirty times in succession, the following message is displayed and the
projector does not accept any more password entries. "The projector's
operation will be locked. Contact Epson as described in your documentation."
s
"Epson Projector Contact List" p.74
Notes on Use
Warning
•
Do not cover the projector's air intake vent or air exhaust vent. If either of
the vents is covered, the internal temperature could rise and cause a fire.
•
Do not look into the lens during projection.
Caution
While projecting, do not put your face or hands near the air exhaust vent, and
do not place objects that may become warped or damaged by heat near the
vent. Hot air from the air exhaust vent could cause burns, warping, or
accidents to occur.
Safety Warnings and Cautions
8