Epson EB-Z10000, Руководство по установке, Страница: 22 / 84

Installation Requirements
a
An optional ceiling mount is required when suspending the projector
from a ceiling.
The projector can be installed at the following angles.
Vertical: Can be installed within an angle range of 100 degrees.
Horizontal: Can be tilted within the range of expansion and contraction for
the front and rear feet.
Make sure there is a gap of at least 50 cm between the wall and the air
exhaust vent and the air intake vent.
When setting up multiple projectors, make sure there is a gap of at least
50 cm between the projectors. Also, make sure the heat coming out of the
air exhaust is not taken in through the air inlet.
When installation is completed, set Direction to Normal , Pointing Down ,
Pointing Up , Angled Up , or Angled Down according to the projecting
direction of the projector.
Press the [Menu] button > Extended > Direction
Adjusting the Position of the Projected Image
(Lens Shift)
a
Press the [Lens Shift] button on the Remote Control. When using
the control panel of the projector, press the [Lens] button three
times.
b
To adjust the position of the projected image, use the [
h
] button
on the remote control or the [
w
/ ][
v
/ ][
<
/ ][
>
/ ] buttons
on the control panel.
a
•
We recommend setting the focus, zoom, and lens shift at least 30
minutes after you start the projection, because images are not stable
right after turning on the projector.
•
The image will be clearest when both the vertical and horizontal lens
shift are set in the center.
Installing the Projector
22