Epson AcuLaser C2000, Руководство администратора

Страница: 31 / 272

2
Connecting to the Network
2-13
❏
In the following, we will assume that the MAC address of your
Internal Print Server is 00:00:48:93:00:00 (hexadecimal); and the
IP address which you will be assigning is 192.168.100.201
(decimal). Substitute your values for these addresses when you enter
the commands.
1. From the command line, type the IP address of the Internal
Print Server and its MAC address:
Example:
arp -s 192.168.100.201 00-00-48-93-00-00
2. You can now check the new IP address, by “pinging” it:
Example:
ping 192.168.100.201
3. The Internal Print Server should now respond to the ping. If
it does not, you may have entered the MAC address or the IP
address in the ARP -s command incorrectly. Double-check
and try again. If you are still unsuccessful, re-initialize the
Internal Print Server and try again.
4. You can check whether the IP address has been set correctly
on a network status sheet.
Note:
❏
You cannot print a status sheet before you set a new IP address.
❏
You can only set the IP address using the arp and ping commands.
To change the subnet mask or default gateway of the Internal Print
Server, make settings on the printer’s control panel or use the
EpsonNet WinAssist/MacAssist/WebAssist to change these
parameters.
❏
If the Internal Print Server or the computer is unreachable, you
should check the following: the address is correct in the ping
command, the Ethernet connection to the printer and to the host has
been made correctly, and all hubs, routers, etc. are switched on.