5.
Position the drive cable over the system board connector so
that the side with the red wire is closest to the pin
identification markings “1” and “2” printed on the system
board.
6.
Make sure the holes in the ribbon cable connector fit over the
pins in the system board connector; then push in the ribbon
cable connector.
Caution
If you do not correctly align the holes with the pins, you
could severely damage your system board when you
push in the ribbon cable connector.
7.
Now locate the side of the hard drive connector that contains
pin 1. The number “1” or “2” may be stamped on the
connector casing or printed on the drive’s circuit board to
identify the side of the connector containing pin 1. If the
number does not appear on the connector casing, remove
the drive and turn it over to check the circuit board.
4-6
Installing and Removing Drives
Содержание ActionTower 2000
Страница 1: ......
Страница 15: ...Glossary Index EPSON U S and International Marketing Locations V l l l ...
Страница 87: ...4 20 Installing and Removing Drives ...