Epson ActionTower 2000, Руководство пользователя

Страница: 64 / 131

Follow these steps to install video memory:
1. Locate the video memory chip sockets on the main system
board, shown on page 3-6.
2. If there is an option card in your way, remove it. See page
3-18 for instructions.
Caution
To avoid generating static electricity and damaging the
memory chips, ground yourself by touching the metal
surface on the inside of the computer’s back panel. Then
remain as stationary as possible while you install them.
3. Remove the memory chips from their package and inspect
each one. The pins should point inward at slightly less than
a 90º angle. If any pins are not in this position, use your
fingers or small tweezers to gently align them with the
others. Be careful; the pins are fragile and can break easily.
4. Position the memory chip over the first empty socket as
shown below, aligning the pins on the chip with the holes
in the socket. Make sure the small notch on the end of the
chip aligns with the corresponding notch in the socket.
notches
Installing and Removing Options
3-19